Dositec 60AG-185/3 180W 3 Phase Turbine Agitator – 1.1m Shaft, Up to 600L

The Dositec 60AG-185/3 is designed to mix liquid chemicals and water-soluble products in dosing, irrigation, fertigation and water treatment tanks. Its turbine produces both radial and axial circulation to help mix the full tank volume and reduce settling at the bottom.

This model is suitable for tanks up to approximately 600 litres, with a recommended maximum tank diameter of around 0.8 metres.

Yes. The 60AG-185/3 uses a 185W three-phase motor designed for approximately 230–430V, 50Hz operation. Electrical installation should be completed by a qualified electrician.

The agitator is supplied with a 1.1-metre stainless steel shaft. The manufacturer allows the shaft to be shortened during installation when required to suit the tank depth.

Yes. The stainless steel shaft can be shortened using a suitable hand saw. After cutting, the turbine must be removed and correctly refitted to the new shaft end before operation.

The agitator uses an AISI 304 stainless steel shaft, a polypropylene turbine, a polypropylene flange and AISI 304 stainless steel fasteners. These materials are suitable for many common dosing and agricultural chemical applications.

No. The turbine must remain fully submerged while the agitator is operating. Running the unit with the turbine exposed can damage the equipment and create unsafe operating conditions.

The recommended maximum liquid viscosity is 80mPa·s, with a maximum liquid density of 1.5g/cm³. For thicker or heavier products, suitability should be checked before installation.

The standard operating temperature range is 0°C to 50°C. Applications above 50°C should be reviewed with the manufacturer before use.

Yes. Suitable motor overload protection must be installed according to the motor specifications. The motor must also be correctly earthed and wired to rotate in the direction indicated by the manufacturer.